Help You Understand The Characteristics Of Thermoset Bulk Molding Compounds
Oct 10, 2024
Leave a message
1. General properties: The density of BMC molding compound is large, between 1.3~2.1 g/cm3; The appearance of the product is bright, the feel is good, and there is a feeling of hard and heavy; Heating with fire produces a lot of oil smoke and has a styrene smell; Some varieties of BMC molding compounds are flame retardant, but some varieties are extremely flammable, leaving inorganic substances after combustion.
2. Dimensional stability: The linear expansion coefficient of BMC molding compound is (1.3-3.5)×10-5K-1, which is smaller than that of general thermoplastics, so that BMC molding compound has high dimensional stability and dimensional accuracy.
Temperature has little effect on the dimensional stability of BMC molding compounds, but the effect of humidity is more severe, and BMC expands after moisture absorption. The coefficient of linear expansion of BMC molding compounds is very similar to that of steel and aluminum, so it can be compounded with them.
3. Mechanical strength: The tensile, bending, and impact strength of BMC molding compounds are higher than those of thermoplastics, and the creep resistance is also better than that of thermoplastics.
4. Water and solvent resistance: BMC molding compounds have good chemical resistance to water, ethanol, aliphatic hydrocarbons, greases, oils, but are not resistant to ketones, chlorine hydrocarbons, aromatic hydrocarbons, acids and alkalis, etc. BMC molding compounds have low water absorption and still have good insulation properties after one day of soaking.
5. Heat resistance: The heat resistance of BMC molding compounds is better than that of general engineering plastics, and the heat deflection temperature is 200~280°C, which can be used at a temperature of 130°C for a long time.
6. Aging resistance: BMC molding compound has good aging resistance, can be used indoors for 15~20 years, and its strength retention rate is more than 60% after 10 years of outdoor exposure.
7. Electrical properties: BMC molding compounds have the most outstanding arc resistance, which can reach about 190 s.
8. Low odor: The styrene crosslinker used in BMC molding compounds will still have 0.1% residue after curing, and it will emit odor when heated. Therefore, BMC molding compounds used in food utensils (e.g., microwave oven tableware) should be unsaturated polyester (UP) resins of the type of styrene monomer with no residue.
Send Inquiry








